To Fit This Mouthguard You Will Need:
- Fill saucepan with 3 to 4 inches of water. Bring water to a rolling boil.
- Remove water from heat source. Let water stand for 30 seconds, then place mouthguard in water for 60 seconds. Do not exceed 60 seconds. For strapped mouthguards, attach tether before placing in water.
- Carefully remove mouthguard from hot water with a slotted spoon or by the tether.
- Cool mouthguard in tap water for 1-2 seconds only to bring surface temperature to a comfortable level.
- Lick your lips before placing mouthguard in your mouth.
- Watching in mirror, line up mouthguard carefully with the centerline of upper teeth. Fit mouthguard onto and around upper teeth and press firmly into molars first then front teeth.
- Bring lower jaw forward and up into base of mouthguard with teeth in alignment with lower channel. Bite down hard on mouthguard, suck in strongly, and use fingers to press edges of mouthguard into teeth and gum line through lips and cheeks for 20 seconds.
- Remove mouthguard and cool in cold water for 30 seconds. Replace into mouth and test for a good, firm fit.
- Repeat steps 1 through 8 if fit is not accurate.
Click here for a printable version of these instructions
- The Gel Max Power Mouthguard will expand up to 20% during the fitting process when molded correctly. It may seem small at first but it will fit! (see below for before & after reference)
- If you didn't get the perfect fit the first time, you can try again! Just repeat the process from the beginning
- The Gel Max Power Mouthguard is not compatible with braces, but we have a wide variety of Braces Mouthguards available. If you already bought a Gel Max and need a braces mouthguard instead, contact us and we'll exchange it free of charge.
If for any reason your mouthguard does not fit perfectly, please contact us at firstname.lastname@example.org and we will assist you in getting the perfect fit.